Wykabor 10

Product code:	WYKBOR1025LT
Pack size:	25 litres

Wykabor 10 Preservative Biocide

Aqueous boron based wood preservative and masonry biocide.

Suitable for treatment and prevention of wood boring insect attack and fungal attack on wood, including common furniture beetle (Anobium punctatum).
Suitable for prevention of fungal attack in sound timbers following removal of sources of moisture.
Suitable for eradicant treatment of fungal attack in timbers, in conjuction with Wykamol 40.
Suitable for control of dry rot (Serpula lacrymans), moulds, algae, mosses and lichens on masonry.
Good penetration.
Low odour.
Non-flammable.
Suitable for application by brush, immersion or coarse spray.
Active ingredients: Benzalkonium chloride, Disodium octaborate.
COSHH (Control of Substances Hazardous to Health) Regulations 1999 apply to the use of this product. Consult supplier.

More about Wykabor 10 Preservative Biocide

Product reference: Wykabor 10 Preservative Biocide

Function: [Preventative, on timber]
[Remedial, insect attack on timber; as drawing ___]
[Remedial, organic material control on masonry; as drawing ___]
[Remedial, fungal attack on timber; as drawing ___]
- Includes dry rot, wet rot.Application: . . . . . .

Application: [Brush, 0.25 L/m²]
[Immersion] - For new timber (minimum): 3 minutes. 5–20 L/m³.
[Spray] - Low pressure: 210–350 kPa. 0.25 L/m².
[Contractor's choice]

Standard Product Features

Preparation:

– General:

Thoroughly clean timbers using stiff brush and vacuum.

– Existing timber, insect attack:

Check structural integrity of timbers. Remove and replace structurally unsound timbers.
Remove paint and other surface finishes which might inhibit absorption of Wykabor 10.

– Existing timber, fungal attack:

Eliminate source of dampness and allow timbers to dry before treatment.

– Existing masonry, organic material:

Physically remove growth before treatment.

Application:

– Existing masonry, dry rot:

115 mm walls: Apply by brush or spray, one face.
230 mm walls: Apply by brush or spray, both faces.
Walls thicker than 230 mm: Drill at 225 mm centres for low pressure injection or gravity irrigation.

– Existing masonry, control of organic material:

Initial application by brush or spray. Remove dead growth. Second application by brush or spray.

Decoration:

Treated timbers can be overcoated when dry.
Treated masonry, interval before plastering (minimum): 48 hours.